Leading Edge Radius and Shape Detail at the Front of the Keel Stub

published 09/13/2021

---

What is leading edge radius and shape detail for the front of the keel stub near where the keel meets the hull?

• The leading edge radius should be the same as the keel leading edge radius and the measurer has allowed a maximum 4” vertical area above the keel for the builder to fair this area in. The shape in this area is defined by the mould, and is checked with the Keel Stub Stem Template.

Is it permitted to change the approved mould in order to change the leading edge radius and shape detail at the front of the keel stub near where the keel meets the hull?

• D.2.6.(d) applies.
• No, it is not permitted.

Submission from Swan River Fleet, April 26, 2021

---